I probably will set it up to measure out the Flora series GH nutes for an arbitrary volume of water.
Edit: Grammar
Maybe set up a special mix for topping off the reservoir.
Whilst changing the water in my reservoir, I noticed some of the leaves on my Fatali plant were curling. This is what I found on the backside of the curled leaves.
I beseech ye sages of pestilence, what is murdering my plant?
The same thing happened with the plants I started in my Aerogarden 3 last year. I ended up taking the advice of the local hydroponic shop owner and cutting them apart with a razor blade.
After transplant.
2 months after
I don't know of any books off of the top of my head. I'd start with an Arduino or a PICAXE and use the various communities and forums for each for a reference.
I developed and etched the board with a common photographic process using a positive image from Eagle.
Edit: Moved design files to GIT
That stamp communicates with the MCU via a serial connection, accepting commands and is setup for 3 point calibration tests via serial commands.
As far as keeping a desired pH value, I can use the same method the setup currently uses to set target temperature and relative humidity via a menu...
Thanks to lazy, I was able to start working on this again. He keeps saying I should build kits.. maybe.
This is the prototype for the environmental controller portion, funded by lazy. It is setup to regulate temperature and RH in a grow tent. Far more switching power than what is needed...