BBQ Mods

Deathtosnails · Mar 5, 2016

Had an idea for a tiled table for the Weber. First slap up pretty good. Gonna sink some bolts deeper into the hardwood and sand back. Stain the structural HPTP and then 2 coats clear polyurethane. Gonna also silicone the tiles and grout a lip where the 'Q meets the tiles and under too.

Pretty happy with how it's come together.

I have plans for the tiled bit from the hole...

Gotta make a thingey to hang the lid and gonna make some other mods for tools and possibly a cabinet on the left half for charcoal and bits and bobs

tctenten · Mar 5, 2016

Very nice! I am looking to do something similar for my WSM.

Sizzle Lips · Mar 5, 2016

Looks good...nice job.

Roguejim · Mar 5, 2016

Class! Seeing the tile reminded of a side table design by KAT Fabrication for their Santa Maria grill. The 16"x16" tile sits in a steel frame on either side of the grill, so that when the tile gets stained or cracked, it can be easily popped out and replaced. Simple..

Phil · Mar 28, 2016

Nice! Is there anything protecting the wood from heat around the bottom of the kettle?

Scovie · Mar 28, 2016

If you use plywood, as the base, then Hardi-Backer® cement board, cut the hole in the plywood 3" bigger than the BBQ, cut the Hardi-Backer and tile to the finished size, it can take the heat.

I'll just put these here for no particular reason.

BBQ Mods

Deathtosnails

tctenten

Sizzle Lips

Roguejim

Phil

Scovie